Solutions Products Support About Us Find a Distributor Contact Us
Solutions Products Support About Us
Solutions Products Support
Logo - TRIM™ wrapped with Metalworking Fluids and Master Fluid Solutions, teal
Logo - TRIM™ wrapped with Metalworking Fluids and Master Fluid Solutions, teal
TRIM™ TC 241A

Antifoam

Description

TRIM TC 241A is a long lasting antifoam that does not contain any of the silicone or poly-siloxane ingredients usually found in antifoam. This unique formula results in much longer functional life when compared to traditional antifoams.

  • Only add to synthetic fluids
  • Use 0.01 (100 PPM) as the add rate
  • Pre-mix in either clean water or coolant working solution
  • Adding a little at a time, “up stream” of the filter helps to ensure maximum effectiveness
  • When properly mixed into the working solution, TRIM TC 241A will pass through filtration down to 2 microns, however, when not properly mixed, it may be filtered out
  • This material is very stable, and when properly mixed, three to four weeks between adds is typical
  • Fluid temperatures must be 21°C or higher at the point of agitation

TRIM™ TC 241A   
©2017-2024 Master Fluid Solutions™